Hiti P520L Manuale Utente Pagina 1

P520L PC-Link Dye-Sub Printer User Manual

10 => USB cable => Warranty card

11 Chapter 3. Basic functions introduction ◎ Appearance ❷ ❶ ❸

12 ◎ LCD Display No. Name Function ❶ Door Press the button to open the front door ❷ Control panel Four hard-key and one mono LCM to control a

13 (Type B) purpose ❻ Power Switch Switch “On” to operate, and switch “Off” when finishing using the printer. Do not switch off the printer while t

14 Chapter 4. Installing and operation Connect the power cord which is conformed to safety regulations below. ◎ Installing : Make sure to sw

15 : Please avoid piling up which may cause the fire and electric shock. Connect the USB cable with printer and PC/laptop for further operation.

16 ◎ Ribbon/Paper Installing Install paper adapters in the paper flange first while using 5x7 paper size. However, the paper adapters are not neces

17 *Accessory item: => Paper flange x 2 (1x Black and 1x white) 4.5.1 Loading paper instructions Place the paper flange in right positions.

18 ◎ Printer transportation The following cautions are necessary in transportation of the printer. Since an incorrect transportation method caus

19 Chapter 5. Operation panel and Printer Status ◎ Operation Panel No. Name Function ❾ Left button Use this button to select preferred s

2 Contents Regulatory compliance statements... 3 Chapter 1. Important

20 down System warm up The thermal head is being warmed up. Printing is interrupted temporarily until the thermal head is warmed up ◎ User Set Up M

21 ◎ Cleaning of Thermal Printing Head and Roller By using thermal transfer technology, daily maintenance is not necessary if the printer has been u

22 ：Please wait 5 minutes until the gauze dried up completely ◎ Cleaning of Outer Cabinet cleaning Wipe the printer with a soft cloth. If the strain

23 Chapter 7. Error Message Handling ◎ Error Message and Corrective Actions LCD Message Status Corrective Action 0100 Cover Open The front cov

24 lamp us lit The front cover does not open ● Check if the printer is installed in a flat surface ● Please check if there is hindrance for openin

25 ＊ Attention: If the paper is used without cutting off the folded or printer section, paper jam occurs every time or the ribbon may snap during

26 Chapter 8. Specification 7.4 Stick the broken part of ribbon with a tape. 7.5 Turn the ribbon on the rewinding side and rewind

27 ◎ Specification Model Name HiTi P520L Printing Method Dye Diffusion Thermal Transfer (D2T2 Technology) Resolution 300 x 300 dpi Printing Size

Regulatory compliance statements American Users FCC Part 15 For a Class A digital device or peripheral, the instructions furnished the user shall inc

4 Federal Communications Commission (FCC) Statement You are cautioned that changes or modifications not expressly approved by the part responsible

5 Chapter 1. Important safety instruction ◎ Safety Instruction This manual provides detail instructions for the safety use of the printer. Please

6 : Do not place the printer under a humid or dusty place. It can cause a fire, electric shock or printer problem. Do not place the printer with dust

7 : When moving the printer, hold the bottom edge of the printer. It is strongly recommended to handle the printer by one to two persons during the t

8 : This product must be grounded at all time during operation, and always used with the specified power cable only or the power cable accompanying t

9 Chapter 2. Accessory items Before using the printer, please make sure the Chapter 1. Important Safety Instruction is fully-acknowledged carefully